Jet Ski Service,jet ski Repair and jet ski Parts shop in GOLD COAST, Brisbane. Yamaha WaveRunner,Kawasaki Jet Ski,BRP SeaDoo
29.9.11
24.9.11
20.9.11
16.9.11
New item for dispose of oil filter
We get oil filter cutter for environment.
LH after soak, RH before soak.
14.9.11
12.9.11
Service Kawasaki STX-15F
Customer covered in air intake mouth by rag for avoid to water get into when rinse engine room but he forgot to remove this rag and stated engine.
10.9.11
YPVS valves fitted up side down of YAMAHA XL1200 Lim
9.9.11
Problem of RIVA EFI control unit for GP1300R
This control unit fitted GP1300R as ski damaged body repoted few days ago. Then I disconnected all wire harness and found problem.
Worst case water or moisture get through inside of coupler and damaged or corrode terminals. This may occur to won't engine start or lost power because this harness are all sensors line.
This pictures are other customers GP1300R as fitted RIVA EFI control unit. This couplers had no blind plugs too and damaged most terminals as ski runs bad.
6.9.11
Ouch! damaged body of GP1300R by KARATE-Chop
When customer fell from ski he chopped deck and ski damaged like a picture and his arm was broken,,,,,, Ouch!
3.9.11
Stator leads joint ,,,,,
Old Super Jet motor had spark problem
This stator coil leads had been jointedAll leads corroded because just covered by non water proof heat shrink.
Fixed by water proof heat shrink joints. So now motor get good sparks.
1.9.11
Subscribe to:
Posts (Atom)